instructions for use of gas and electric heating teppanyaki hibachi grill

Common Japanese Teppanyaki equipment, Korean Teppanyaki equipment, and French Teppanyaki equipment are equipped with two types of heating methods, one is a gas heating device, and the other is an electric heating device. No matter how expensive your Teppanyaki equipment is, if you use it carelessly, the Smokeless Teppanyaki Table will be damaged, and the service life and safety of the Japanese Teppanyaki Grill Table will be greatly shortened. So what should we pay attention to when using these Teppanyaki equipment heating devices?

Fierst. Instructions for the operation procedure of gas teppanyaki (without flameout protection device)

1. First turn on the main power switch, then turn on the fan switch, and turn the air valve clockwise to a horizontal position (at this time, the air volume is large).

2. Open the gas master valve to prepare for ignition, first turn the damper with the tinder written counterclockwise to the ON position (at this time the tinder valve is open), and press the ignition button at the same time, observe whether the fire in the shut-off hole is ignited. Turn on the main fire.

3. If the equipment is equipped with a fume purifier, please turn it on before cooking.

4. If you need to turn off the equipment, you should first turn off the main fire valve, and then turn off the fire valve and the power switch in sequence.

5. Non-combustible if ignited several times. Need to check whether the ignition wire and battery are invalid. Also check that the gas source is in place.

Second. Instructions for the operation procedure of gas teppanyaki (with flameout protection device)

1. First turn on the main power switch, then turn on the fan switch, and turn the air valve clockwise to the horizontal position (at this time, the maximum suction volume).

2. Open the gas master valve to prepare for ignition, press the gas switch and rotate it 15 degrees counterclockwise, and press the ignition button at the same time, observe whether the fire in the fire-off hole is ignited. After the fire is ignited, the gas valve cannot be released and continue to press the air valve 12 Release in about seconds, at this time the main fire is turned on and the fire power is at the maximum position.

3. If you want to turn off the main fire, you can press the gas switch and rotate it to the 170 degree position in a counterclockwise direction. At this time, the main fire power is at the minimum position.

4. If the equipment is equipped with a fume purifier, please turn it on before cooking.

5. If you need to turn off the equipment, press the gas switch and rotate it clockwise to the 0 degree position, that is, the main fire is turned off, and then turn off the fan and the power switch.

6. If the ignition is non-combustible several times, it is necessary to check whether the ignition wire and battery are invalid. Also check that the gas source is in place.

Warning: The gas equipment must be turned on before the ignition!

Third. Instructions for the operation procedure of electric heating Teppanyaki

1. Turn on the power switch.

2. First turn on the power on button on the control panel, and then set the temperature to be cooked. The steps to set the temperature are as follows:

a. Press the SET button on the temperature controller, and the number in the SV box flashes.

b. Press ∧ or ∨ key to adjust the set temperature value. (The best use temperature of Teppanyaki is 220 degrees).

c. After the temperature value is adjusted, press the SET key. At this time, the number in the SV box stops flashing, and the temperature setting is completed.

3. After the temperature is set, press the heating key, fan key, and purifier key in turn.

Note: If the equipment is equipped with a fume purifier, please turn it on before cooking.

4. If you need to turn off the device, press the heating key, fan key, and purifier key in sequence, preferably press the power key.

Warning: Do not press and hold the SET button on the temperature controller for a long time, so as not to cause disorder of the device program!